1.Filling lubricating oil to linear guide
As we know, the smoke and dust that is generated by the engraving and cutting will harm the guide rail following a period of usage, so we want to perform the each day upkeep of the guide rail. Please turn off the laser engraving machine and reduce the energy, clean the guide rail with clean mull, then please drop the lubricating oil around the guide rail, make an effort to move the slide rod and make sure that the oil comes into it. Make the slide rod move on the guide rail immediately after filling the oil, now we need to have to install the guide rail firstly, please do not fix the guide rail firstly, set up the screws inside the proper position and keep the slide ray around the even level. Then fix the belt and slide rod nicely, set up the lens and after that adjust the destination of X light.
2.Clean the reflector and focusing mirror
After a period of usage with the laser engraving and laser cutting machine, the smoke and dust will adhere for the surface of the reflector and mirror, that will impact the engraving and cutting depth and also will influence the engraving and cutting precision. We will need to clean the three reflectors and a single focusing mirror with pure alcohol weekly.
3.Oil-filling for the bearing
A laser engraving machine is equipped with plenty of bearings, in order to hold the good engraving and cutting outcome, portion of bearings have to be refilled with oil frequently (except the oil-retaining bearing). Wipe off the surface dust around the bearing with all the clean mull, take a piece of injector and suck some engine oil inside, then fill the bearing with pinhead and move the bearing in the exact same time.
4.Adjustment of synchronous belt
There are some synchronous belts on a single laser engraving machines, when the synchronous belt is too loose that will lead to the double images of your engraved words, when the synchronous belt is as well tight which will lead to the abrasion of synchronous belt. After a period of usage, please adjust the taut screws of synchronous belt, adjust the synchronous belt until its degree of tightness is suitable, it truly is adequate when there’s no double photos from the engraved words along with the noise from the laser engraving and laser cutting machine is very low, or you could seek advice from our technician.
5.Maintenance with the laser tube
The laser tube of your laser engraving machine is using the cycle water as cooling program and because the time goes on, there is going to be some furings inside the laser tube. We we are able to place slightly vinegar into the cycle water, the vinegar will melt the furing. Soon after that, we shall use some clean water to clean the tube. So the laser tube will be in the very best operating situation and its life will grow to be longer. Get more details at laser welding machine
